Hello, welcome to the official website of Shanghai sanhuai International Trade Co., Ltd!
National consultation hotline
National consultation hotline
During the operation of the homogeneous emulsifier, if there are abnormal noises or other common faults, the equipment should be stopped immediately for inspection, and then run after the fault is detected. After stopping operation, the working chamber and stator and rotor should be clean.
For example, the process working chamber can be equipped with a thermal insulation layer to cool or heat the material, and the cooling liquid or heat-conducting oil should be injected first when the machine is turned on. The thermal insulation interlayer with working pressure ≤ 0.2Mpa needs to be heated or cooled to normal working temperature when processing has temperature requirements (such as asphalt), crank the car, and start the machine.
When the homogeneous emulsifier is used in a flammable and explosive working environment, an explosion-proof motor of the corresponding level should be selected.
After the production is completed, the equipment needs to be cleaned so as to not only maintain the working efficiency of the stator and rotor, but also play the function of protecting the mechanical seal. If necessary, design and install a set of ring cleaning equipment.
Depending on the media used by the consumer, the inlet and outlet filters are regularly cleaned to avoid reduced feed volume affecting manufacturing efficiency. The material entering the working chamber must be fluid. Dry powder, agglomerate and other materials are not allowed to directly enter the machine equipment. Otherwise, the machine equipment will be damp and damage the machine equipment.
The homogeneous emulsifier needs to maintain the stator and rotor regularly. If it is found that the wear is too large, the corresponding parts should be replaced in time to ensure the actual effect of dispersion and emulsification.
When liquid leakage is found on the shaft during operation, it is necessary to adjust the mechanical seal pressure after stopping the operation of the equipment.
Before using this machine and equipment, corresponding safety production operation procedures should be formulated to ensure the safety of operators and equipment. Electrical control system consumers should set up a safety protection system, and the electric motor should play a safe and reliable grounding device.
The above are all the precautions that need to be paid attention to when using the homogeneous emulsifying machine to process materials. I hope that after reading it, it will be helpful to everyone! The equipment of the homogeneous emulsifier itself is a very advantageous equipment for processing raw materials, but everyone still can't get away with it. It is necessary to repair the homogeneous emulsifier in peacetime, and at the same time pay attention to the operation method, so that it can be reasonably extended. The lifespan of the homogenizer!
Shanghai Sanhuai International Trade Co., Ltd. is mainly engaged in the production and manufacture of mechanical products, focusing on the development and production of various mechanical products, mainly producing daily chemical machinery, pharmaceutical machinery, packaging machinery, food machinery and various stainless steel products.
Shanghai Sanhuai International Trade Co., Ltd.
Wechat QR code
Wechat：13386259279Copyright ?2022 Shanghai Sanhuai International Trade Co., Ltd. ALL Rights Reserved Hu ICP Bei No. 19029947
Technical support ：Sueasy